About the role
Job Overview: The primary initial task for this position is to provide support to project lead and team electrical engineers on day-to-day discipline coordination issues, schedule updates, to assist with requisition paperwork, document redlining, and meeting notes, and to become familiar with the discipline activities, deliverables, and team dynamic. Additional potential activities may involve any combination of those described below.
In general, the expectation of Electrical Engineers should perform electrical engineering for power, oil and gas, and petrochemical projects. Design, analyze and prepare complex project deliverables for power generation systems, substations, power distribution systems, lighting & grounding systems, and other engineering systems as required by each project. Provide technical support for engineering, fabrication and construction.
Key Tasks and Responsibilities: Prepare key project deliverables, including (but not limited to) the following: Specifications and Datasheets Electrical Load List One-line diagrams Motor control schematics Electrical building and equipment layouts Bills of Material Cable sizing calculations Conceptual studies and calculations Cost and planning studies
Support Project Development and Coordination, including (but not limited to) the following:
Maintain and promote a focus on McDermott’s end-product throughout engineering, fabrication or construction
Report to and coordinate with electrical engineering project lead and electrical task lead, as applicable
Effectively communicate with electrical and other disciplines engineering and design
Coordinate and manage change with full awareness of project impact
Assume responsibility for cost, schedule, and quantity and budget control
Develop and review vendor packages, including (but not limited to) the following:
Create requisition packages for Substations, Transformers, and Electrical materials
Create subcontract packages for Heat Tracing, Cathodic Protection and Electrical Installation
Review supplier documents for electrical and non-electrical packages
Attend Inspection and Factory Acceptance Testing (FAT) of electrical equipment, motors and associated skids
Provide Site Support, including (but not limited to) the following:
Provide off-site and/or on-site technical support to Construction personnel
Coordinate with office personnel to resolve issues as needed
Provide technical support for Site Acceptance Testing (SAT) of electrical equipment
Assist with precommissioning, energization, commissioning and start-up, as required by project
Essential Qualifications and Education: Accredited engineering degree may be required by specific regions
Minimum 3-5 years of detailed electrical engineering experience
Familiarity with the content and application of standards, codes and guidelines, including NEC, NFPA, IEEE and ANSI, and latest scientific and engineering methods
Technical knowledge of the detailed design engineering process
MS Office Suite including Excel and Word
Preferred Qualifications and Education: Prefer BSEE degree
Prefer PE or EIT certificate of registration
Experience with Smart Plant Electrical (SPEL), Aveva Electrical/Unified Engineering, ETAP
Prefer experience with Renewable sources – wind, solar, BESS
Prefer experience with Data Center power system design and engineering
#LI-CA1